Sure Edge Gutter Drip Trim
Pins & Joining Clips Included
Sure Edge Gutter Drip Trim 2.5m
The Gutter drip trim simplifies your roof edge and is used to secure the membrane where water runs off the roof. The drip edge is a two part trim that clamps the membrane into place and creates a step into the gutter.
Ideal for Professional & DIY roofers alike, just cut to length. Don’t forget to buy your corners.
Height: 75 mm
Length: 2.5 metres
Qty in Pack: 1
(Stainless Pins and Jointing Clips all included)
|Stock Type||Warehouse Fulfilled|
|Brand Name||Sure Edge|
If its going to be a few weeks before you fit the roof, we would suggest unrolling the membrane and re-rolling it longways, this will help prevent any creases forming. The adhesives and trims need to be stored indoors before fitting, rather than leaving them outside, as they can be affected by temperature fluctuations. Check out our video below for a full explanation from Sam!
We sell a wide variety of EPDM rubber flat roofing kits to our customers and try to provide the widest possible selection, with options for many different types of flat roofs available from Orangery Roofs to Garden Rooms. Check our video below for a full breakdown of what to expect in your kit! (The information about the contents of your kit can be found on the product page on our website.)
Fitting a rubber roof to a garden building can be a very quick job if you have some basic knowledge about the preparation and correct steps to take. It can take a professional less than 1.5 hours to fit a garden room roof!