GRP Internal Trim (INT170)
The SkySeal GRP INT170 internal edge trims can be used as a drip trim or to form an external angle
GRP INT170 Internal Trim
The INT170 internal edge trims can be used in place of a tilt fillet on small roofs or to detail an internal corner on a roof. PU trim adhesive should be applied and the trim held in place with pins prior to matting.
This is a Glass Reinforced Polyester flat roof system designed and engineered for flat roof applications. Fully integrated all in one system where the components work together on virtually all types of flat roofs and vertical surfaces in any domestic or commercial application to provide the perfect all weather protection.
A single batten should be fixed on to the outside fascia board level with the top edge of the deck. Cromar PU adhesive should be applied to the battens in 30mm beads.
- Cold applied - No heat needed
- Easy to form
- Durable - Resists heavy foot traffic
- Virtually maintenance free
- Impact resistant
- Fire retardant
- Storm proof
- Frost proof
- Length : 3 metres
- Width : 70 mm
- Height : 100 mm
Please Note- PINS SOLD SEPARATELY.
|Stock Type||Warehouse Fulfilled|
If Installed Correctly a Fibreglass roof has a typical life expectancy in access of 35yrs
Fibreglass roofs must always be laid onto new and dry OSB3 boards. For best results we recommend using tongue and groove boards.
Yes. Fibreglass is a very tough and durable material. This means walking on your roof shouldn't affect the integrity of the roof
Yes, Never Attempt to install a Fibreglass Roof onto wet or damp boards.
The minmum temperature for installing a fibreglass roof is 5 degrees C.